Contact Us

C o n t a c t U s

1-g shaking table tests on seismic enhancement of existing

2018-6-1  The shaking table test device used in the present study is shown in Fig. 1.It has the maximum payload, acceleration and displacement of 16 kN, 9.8 m/s 2 and 0.05 m, respectively. The dimensions of the shaking table shear box are 1.2 m in length, 1.0 m in width and 0.8 m in height.In order to prepare a uniform model ground with a prescribed density, a sand-dropping device, placed on the up-down

Shaking Table Tests on 1/3-Scale Model of Wooden

Therefore, a series of shaking table tests were conducted in this paper. The specimens consisted of three 1 / 3-scale, 3-story, 3-bay, wooden horizontal hybrid structures with diverse shear wall distributions and diaphragm stiffness.

Shaking Table Tests on 1/2 Scale One Story Masonry

Request PDF Shaking Table Tests on 1/2 Scale One Story Masonry Structure A study on the dynamic response of one-story building, made by yellow regular Neapolitan blocks and mortar with poor

Shaking Table Tests on 1 / 3 -Scale Model of Wooden

Request PDF Shaking Table Tests on 1 / 3 -Scale Model of Wooden Horizontal Hybrid Structure In 2010, the Japanese government issued a law to promote the utilization of wood in public buildings.

(PDF) 1-G Shaking Table Tests on Seismic Foundation

1-G Shaking Table Tests on Seismic Foundation Isolation System July 2013 Conference: Proceedings of the 18th International Conference on Soil Mechanics and Geotechnical Engineering, Paris 2013

Shaking Table Tests on 1/4 Scaled Shapeless Stone

2012-4-30  4. SHAKING TABLE TESTS Considering the shaking table size and allowable loading condition, the model scaling factor adopted was 1:4 as shown in Figure 5. Two models were used for shaking table test. The dimensions of both building models were 950mmx950mmx720mm with 100mm thick walls. The sizes of door and

Shaking table tests of 1:4 reduced‐scale models of masonry

2001-3-23  Shaking table tests of 1:4 reduced‐scale models of masonry infilled reinforced concrete frame buildings. Shaking table scaled model test on a high-rise building with CFT frame and composite core wall, European Journal of Environmental and Civil Engineering, 10.1080/19648189.2013.805435, 17, 8, (616-634), (2013). Crossref.

Shaking table tests on shallow foundations over

2020-1-1  1 g shaking table model tests. Fig. 1 displays the test layout and dimensions of the shaking table and its instrumentation. The shaking table had two 36 mm-thick 200 × 60 cm wood blocks, where upper wood block served as a dock on which a container was placed and the lower wood block served as a fixed support; three 1.2 mm-thick steel plates

Shaking table tests on seismic behavior of polypropylene

2019-6-1  Accordingly, the PGAs of shaking table excitations were scaled to five levels during horizontal excitations (from 0.2 g to approximately 1.0 g with a common difference of 0.2 g) (where g = 9.81 m/s 2) or to four levels during vertical excitations (0.2 g, 0.4 g, 0.6 g and 0.7 g) owing to the limitation of shaking table performance.

Shaking table tests on unreinforced load-bearing

2015-4-13  Shaking table tests on unreinforced load-bearing masonry structures 9th International Masonry Conference Guimarães 2014 3 University of Bristol, in the framework of the European project SERIES. The experimental campaign was carried out on six specimens, distributed in two sets and aiming at developing a better understanding of the behaviour of

Shaking table tests on deformation and failure mechanisms

The 2008 Wenchuan earthquake in China induced many landslides. Gigantic slope failures have attracted serious concerns in engineering practice; however, small slope failures should also be investigated as they are more common. In particular, the detailed characteristics of slope failures during earthquakes remain unknown. Therefore, the present study carried out 1-G shaking table tests on a

Shaking table tests of 1:4 reduced‐scale models of masonry

2001-3-23  Shaking table tests of 1:4 reduced‐scale models of masonry infilled reinforced concrete frame buildings. Shaking table scaled model test on a high-rise building with CFT frame and composite core wall, European Journal of Environmental and Civil Engineering, 17, 8, (616), (2013). Crossref. G

Shaking Table Tests on a Physical Model of a Concrete

2016-9-9  The research consists of a series of 1g shaking table tests conducted on the scaled model of the gravity dam. The experiments are conducted at the Physical Modeling Laboratory of School of Civil Engineering, University of Tehran. A parametric study is achieved through change of relative density (Dr) of ground soil. Two tests, namely, Test-1 and

Dynamic behavior of single pile from 1g shaking table tests

TY CONF. T1 Dynamic behavior of single pile from 1g shaking table tests. AU Lim, Hyunsung. AU Jeong, S. PY 2020/1/1. Y1 2020/1/1. N2 In this study, the dynamic behavior of a single pile in dry sand was investigated based on 1g shaking table tests.

Shaking table tests on unreinforced load-bearing

2015-4-13  Shaking table tests on unreinforced load-bearing masonry structures 9th International Masonry Conference Guimarães 2014 3 University of Bristol, in the framework of the European project SERIES. The experimental campaign was carried out on six specimens, distributed in two sets and aiming at developing a better understanding of the behaviour of

Shaking table tests in earthquake geotechnical engineering

Shaking table tests in earthquake geotechnical engineering S. K. Prasad 1,*, I. Towhata 2, G. P. Chandradhara 1 and P. Nanju n daswamy 1 1Department of Civil Engineering, S. J. College of

Shaking table tests on seismic retrofitting of rammed

2016-12-28  The shaking table tests were performed at the laboratory of the Kunming University of Science and Technology in Yunnan Province, China. The shaking table is customized by SERVOTEST Testing Systems Ltd. It has a dimension of 4 m 9 4 m with two degrees of freedom and has a maximum loading capacity of 30 t. The maximum acceleration is 1.0 g,

Shaking Table Tests and Numerical Simulation Analysis of a

2014-2-7  Wang, X, Lu, D, & Hou, G. "Shaking Table Tests and Numerical Simulation Analysis of a 1:15 Scale Model Reinforced Concrete Containment Vessel." Proceedings of the 2013 21st International Conference on Nuclear Engineering. Volume 2: Plant Systems, Construction, Structures and Components; Next Generation Reactors and Advanced Reactors. Chengdu

ESECMASE SHAKING TABLE TESTS AT THE NATIONAL

2015-3-22  This paper presents preliminary results of shaking table tests on two-storey high specimens representing cut-outs of typical terraced houses in low seismicity regions in Central Europe. INTRODUCTION As one part of the European research project ESECMaSE, a series of shaking table tests have been carried out at NTU Athens (Carydis et al. 2007).

SHAKING TABLE COLLAPSE TESTS OF TWO SCALE

2009-8-7  3. SHAKING TABLE TESTS 3.1 General Description Two scale models of the moment resisting frame shown in Figure 1b are used to carry out a series of shaking table tests in which the ground motion intensity is incremented until collapse occurs. The scale is 1:8 due to weight limitations of the shaking table facility.

中国科学院机构知识库网格系统: Shaking table tests on

作者 Zhao, Mingsheng 1; Huang, Dong 2,3,4; Cao, Maosen 5; Qiao, Jianping 2,3,4 刊名 JOURNAL OF VIBROENGINEERING 出版日期 2015-02-01 卷号 17 期号: 1 页码: 382-392 关键词 shaking table model tests dynamic responses seismic slope behavior seismic sliding surface Wenchuan earthquake

Shaking Table Tests on a Physical Model of a Concrete

2016-9-9  The research consists of a series of 1g shaking table tests conducted on the scaled model of the gravity dam. The experiments are conducted at the Physical Modeling Laboratory of School of Civil Engineering, University of Tehran. A parametric study is achieved through change of relative density (Dr) of ground soil. Two tests, namely, Test-1 and

Shaking table tests on unreinforced load-bearing

2015-4-13  Shaking table tests on unreinforced load-bearing masonry structures 9th International Masonry Conference Guimarães 2014 3 University of Bristol, in the framework of the European project SERIES. The experimental campaign was carried out on six specimens, distributed in two sets and aiming at developing a better understanding of the behaviour of

Shaking table tests on seismic retrofitting of rammed

2016-12-28  The shaking table tests were performed at the laboratory of the Kunming University of Science and Technology in Yunnan Province, China. The shaking table is customized by SERVOTEST Testing Systems Ltd. It has a dimension of 4 m 9 4 m with two degrees of freedom and has a maximum loading capacity of 30 t. The maximum acceleration is 1.0 g,

Shaking table tests on shallow foundations

2014-5-16  In this paper the results of shaking table tests on shallow foundations, using dry Hostun RF sand, are presented. These tests were performed in a six-degree of freedom seismic simulator formed by 3 m long square table, able to move 10 t mass with up to 1

Shaking Table Tests and Numerical Simulation Analysis of a

2014-2-7  Wang, X, Lu, D, & Hou, G. "Shaking Table Tests and Numerical Simulation Analysis of a 1:15 Scale Model Reinforced Concrete Containment Vessel." Proceedings of the 2013 21st International Conference on Nuclear Engineering. Volume 2: Plant Systems, Construction, Structures and Components; Next Generation Reactors and Advanced Reactors. Chengdu

ESECMASE SHAKING TABLE TESTS AT THE NATIONAL

2015-3-22  This paper presents preliminary results of shaking table tests on two-storey high specimens representing cut-outs of typical terraced houses in low seismicity regions in Central Europe. INTRODUCTION As one part of the European research project ESECMaSE, a series of shaking table tests have been carried out at NTU Athens (Carydis et al. 2007).

A 1-g shaking table investigation on response of a micropile

2018-11-15  Shaking table tests were performed on a 4 × 4 group of vertical micropiles embedded in loose sand. Horizontal acceleration time histories recorded from the 1940 El Centro earthquake and 1995 Kobe earthquake were applied to the base of the soil container.

MATERIALS FOR THE SHAKING TABLE TESTS

2020-9-24  The study of the material that will be used for shaking table tests and the preparation of the equipment setup in the laboratory continues. In the next few months, static tests will be developed that will allow the selected materials to be characterised, in order to choose the most suitable one of the experimental analyses.

Performance of Small Scale Model Slopes in Shaking

2017-5-14  The shaking table tests are conducted on small scale embankment slopes to study their behavior under dynamic conditions. Medium grained local sand with a water content of 3% is used in the study. The slope angle for the model slope is kept at 35 0 with three slope heights of 0.15, 0.18 and 0.21 m. All the three slope models are tested